Configuring Input Actions
Inputs are configured by defining one or more actions to be triggered on an input event. The various input functions available are listed below.
To display the available input actions:
- Click Components at the lower-left of the window.
- Click Input Actions
Available input actions are:
- Activity Indicator
- Advanced Audio Program Control
- Alarm Control
- Audio Program Control
- Backup Request
- Call Escalation
- Clear Activity
- External Fault
- Line Measurement
- Live Speech
- Local Mute Control
- Message Control
- Microphone Test
- Panel Lamp Test
- Recall, Control
- Recall, Record
- System Status
- Tick Tone Control
- Volume Control
- Zone Selection
Configuration
Input actions can be assigned to either a key or a control input depending on system requirements.
These can be configured by dragging-and-dropping the different functions to either Control Inputs on Amplifiers or Programmable Keys on Access Panels, e.g.:
- Drag-and-drop Input Actions to Access Panel > Programmable Keys > p1-px
- Click Done.
- press_action will be automatically configured to Start the activity
- release_action will be automatically configured to Stop the activity
Activation
Start: This will start the broadcast in the selected zone/s and run for the number of repetitions configured or until it is stopped.
Stop: This will stop the selected broadcast if it has a higher priority than the active broadcast in the selected zone.
Toggle: This works as a start/stop function. If the broadcast is not active in the selected zone, it will work as a start function. If the selected broadcast is active in the zone, it will work as a stop function.
or
- Drag-and-drop Input Actions to Amplifier > Control Inputs > CI_1-CI_6
- Click Done
- on_action will be automatically configured to Start the activity
- off_action will be automatically configured to Stop the activity
