Turbine Image Recovery

This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.

It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.

This applies to the following devices:

• ESC1 Controller - only the Secondary System Controller
• ENA Amplifiers
• ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels
• EAPII-1/EAPII-6 Access Panels
• TKIS-2/TKIE-1/TKIE-2 kits

Upgrade Procedures

A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found here.