IP Configuration
Jump to navigation
Jump to search
This article describes how to configure the IP settings in Exigo.
Initially all devices must be configured with:
- Own IP address
- IP Address of Primary System Controller
- ID number (Directory Number)
- Default Gateway
Creating a table with relevant information is considered good practice.
Primary System Controller
To set the IP address for the Primary System Controller:
- Open the front cover on the ESC1.
- Connect a PC to the service port (npe_eth0). This has 169.254.1.5 as the default IP address.
- Log on with a web browser (Username=admin / Password=alphaadmin)
- Navigate to System Configuration > Interfaces
- Set the desired IP Address of the Primary System Controller (npe_eth1)
Secondary System Controller
To configure the IP setting for the Secondary System Controller:
- Connect a PC to either Eth1 or Eth2 ports on ESC1
- Log on to SSC with a web browser
- Navigate to Station Main > Main Settings
- Domain Controller IP: Set IP address of the Primary System Controller
- Directory Number: Set the Directory Number
- IP-address: Set the IP Address of the SSC
- Gateway: Set the default Gateway. A good practice is to set the default Gateway to: x.x.x.1.
Exigo Devices (Amplifiers, Panels and Kits)
To configure the IP setting for Exigo devices:
- Log on to the device with a web browser
- Navigate to Station Main > Main Settings
- Domain Controller IP: Set IP address of the Primary System Controller
- Directory Number: Set the Directory Number
- IP-address: Set the IP Address of the device
- Gateway: Set the default Gateway. A good practice is to set the default Gateway to: x.x.x.1.