IP Configuration

Best practice - Create a table with all relevant information

This article describes how to configure the IP settings in Exigo.
Initially all devices must be configured with:

• Own IP address
• IP Address of Primary System Controller
• ID number (Directory Number)
• Default Gateway

Creating a table with relevant information is considered good practice.

Primary System Controller

To set the IP address for the Primary System Controller:

• Open the front cover on the ESC1.
• Connect a PC to the service port (npe_eth0). This has 169.254.1.5 as the default IP address.
• Log on with a web browser (Username=admin / Password=alphaadmin)
• Navigate to System Configuration > Interfaces

IP configuration for the Primary System Controller

• Set the desired IP Address of the Primary System Controller (npe_eth1)

Secondary System Controller

To configure the IP setting for the Secondary System Controller:

• Connect a PC to either Eth1 or Eth2 on ESC1.
• Log on to SSC with a Web Browser.
• Navigate to Station Main -> Main Settings:

Web interface for the Secondary System Controller

• Set IP address of the Primary System Controller.
• Set the Directory Number.
• Set the IP Address of the SSC.
• Set the default Gateway. A good practice is to set the default Gateway to: x.x.x.1.

Exigo devices (Amplifiers, panels and kits)

To configure the IP setting for Exigo devices:

• Log on to the device with a Web Browser.
• Navigate to Station Main -> Main Settings:

Web Interface for the ECPIR-3P

• Set IP address of the Primary System Controller.
• Set the Directory Number.
• Set the IP Address of the SSC.
• Set the default Gateway. A good practice is to set the default Gateway to: x.x.x.1.