Difference between revisions of "Turbine Image Recovery"
Jump to navigation
Jump to search
| Line 8: | Line 8: | ||
* [[:Category:Indoor Access Panels|ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels]] | * [[:Category:Indoor Access Panels|ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels]] | ||
* [[:Category:Outdoor_Access_Panels|EAPII-1/EAPII-6 Access Panels]] | * [[:Category:Outdoor_Access_Panels|EAPII-1/EAPII-6 Access Panels]] | ||
| − | * TKIS-2/TKIE-1/TKIE-2 kits | + | * [[:Category:Kits|TKIS-2/TKIE-1/TKIE-2 kits]] |
== Upgrade Procedures == | == Upgrade Procedures == | ||
Latest revision as of 12:54, 17 December 2018
This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.
It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.
This applies to the following devices:
- ESC1 Controller - only the Secondary System Controller
- ENA Amplifiers
- ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels
- EAPII-1/EAPII-6 Access Panels
- TKIS-2/TKIE-1/TKIE-2 kits
Upgrade Procedures
A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found here.
