EMT Getting Started

Exigo Management Tool

Factory_Default#Primary_System_Controller

This article describes how to use EMT to create and upload a new database.
Before uploading a complete new database, it is recommended to do a Clean & Factory Default of the controller:

• Log on to the Primary System Controller and go to: System Maintenance > System Recovery > Load Factory Defaults

To create and upload a database in EMT, do the following:

1. Create a New Database
2. Add Amplifiers
3. Define Zones
4. Add Access Panels
5. Upload Database

EMT - Getting Started

Step 1. Create a New Database

In the navigation pane:

• Select Projects

• Click New and follow the instructions in the wizard

EMT - New Database wizard

All of the parameters in the wizard may be changed at a later stage.

Step 2. Add Amplifiers

• Select Components
• Click Devices to open options
  

File:EMT getting started 3.JPG

EMT - Adding Amplifier

• Drag the desired Amplifier into System

Step 3. Define Zones

To add zones to the system:

• Click the + Add Zone button

It is recommended to give the zones a logical name.

EMT - Adding and naming zones

To add amplifier outputs to the zone:

• Either drag the whole Amplifier or the Amplifier output channel to the zone

EMT - Assigning amplifier output to a zone

Step 4. Add Access Panels

• Select Components
• Click Devices to open options

EMT - Adding and naming zones

• Drag the desired Access Panel into System
  

To add functions to the access panel (for example Live Speech) see Live Speech.

Step 5. Upload Database

In the navigation pane:

• Select Projects

EMT - Send - uploads the data base to ESC1

• Click Send to upload the new configuration database to the Exigo system