Difference between revisions of "Turbine Image Recovery"

From exigoWiki
Jump to navigation Jump to search
Line 5: Line 5:
 
This applies to the following devices:
 
This applies to the following devices:
 
* [[ESC1]] Controller - only the Secondary System Controller.
 
* [[ESC1]] Controller - only the Secondary System Controller.
* [[:Category:Central_Equipment ENA Amplifiers]]   
+
* [[:Category:Central_Equipment|ENA Amplifiers]]   
 
* ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
 
* ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
 
* EAPII-1/EAPII-6 Access Panels.
 
* EAPII-1/EAPII-6 Access Panels.

Revision as of 12:51, 17 December 2018

This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.

It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.

This applies to the following devices:

  • ESC1 Controller - only the Secondary System Controller.
  • ENA Amplifiers
  • ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
  • EAPII-1/EAPII-6 Access Panels.
  • TKIS-2/TKIE-1/TKIE-2 kits.

Upgrade Procedures

A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found here.