Difference between revisions of "Turbine Image Recovery"
Jump to navigation
Jump to search
| Line 5: | Line 5: | ||
This applies to the following devices: | This applies to the following devices: | ||
* [[ESC1]] Controller - only the Secondary System Controller. | * [[ESC1]] Controller - only the Secondary System Controller. | ||
| − | * ENA Amplifiers | + | * [[Category:Central_Equipment ENA Amplifiers]] |
* ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels. | * ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels. | ||
* EAPII-1/EAPII-6 Access Panels. | * EAPII-1/EAPII-6 Access Panels. | ||
Revision as of 12:50, 17 December 2018
This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.
It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.
This applies to the following devices:
- ESC1 Controller - only the Secondary System Controller.
- ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
- EAPII-1/EAPII-6 Access Panels.
- TKIS-2/TKIE-1/TKIE-2 kits.
Upgrade Procedures
A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found here.
