Difference between revisions of "Turbine Image Recovery"
Jump to navigation
Jump to search
(→Upgrade Procedures) |
|||
Line 4: | Line 4: | ||
This applies to the following devices: | This applies to the following devices: | ||
− | *ESC1 Controller - only the Secondary System Controller. | + | * [[ESC1]] Controller - only the Secondary System Controller. |
− | *ENA Amplifiers | + | * ENA Amplifiers |
− | *ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels. | + | * ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels. |
− | *EAPII-1/EAPII-6 Access Panels. | + | * EAPII-1/EAPII-6 Access Panels. |
− | *TKIS-2/TKIE-1/TKIE-2 kits. | + | * TKIS-2/TKIE-1/TKIE-2 kits. |
== Upgrade Procedures == | == Upgrade Procedures == |
Revision as of 12:47, 17 December 2018
This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.
It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.
This applies to the following devices:
- ESC1 Controller - only the Secondary System Controller.
- ENA Amplifiers
- ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
- EAPII-1/EAPII-6 Access Panels.
- TKIS-2/TKIE-1/TKIE-2 kits.
Upgrade Procedures
A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found here.