Difference between revisions of "Turbine Image Recovery"

Latest revision as of 12:54, 17 December 2018

This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.

It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.

This applies to the following devices:

A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found here.

@@ Line 1: / Line 1: @@
 This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.
+It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.
 This applies to the following devices:
-*ESC1 Controller - only the Secondary System Controller.
+* [[ESC1]] Controller - only the Secondary System Controller
-*ENA Amplifiers
+* [[:Category:Central_Equipment|ENA Amplifiers]]
-*ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
+* [[:Category:Indoor Access Panels|ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels]]
-*EAPII-1/EAPII-6 Access Panels.
+* [[:Category:Outdoor_Access_Panels|EAPII-1/EAPII-6 Access Panels]]
-*TKIS-2/TKIE-1 kits.
+* [[:Category:Kits|TKIS-2/TKIE-1/TKIE-2 kits]]
-== Prerequisite ==
-In order to upload the firmware you need the following:
-*USB Cable. A toturial on how to make the cable can be found [http://exigowiki.zenitel.com/index.php?title=Turbine_to_PC_physical_connection '''here'''].
+== Upgrade Procedures ==
+A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found [https://wiki.zenitel.com/wiki/Turbine_Stations_-_Image_recovery '''here'''].
 [[Category:Troubleshooting]]