Control Inputs

Devices with Control Inputs available

This article describes the control inputs on Exigo in general.

• Control Inputs are available on:
  • System Controller
  • Amplifiers
  • Access Panels and kits (Not EX panels)

• 6 inputs on each device

• Inputs are used e.g. for triggering:
  • General Alarm
  • Fire Alarm
  • Live Speech from external microphone

Control Inputs - Connections

Connections on rack devises

Rack devices

Connections on access panels

Kits and access panels

Configuration

Configuration of Control Inputs are done in EMT:

Input 1 on amplifier starts «Fire Alarm» message in «Main Building»

• In Components view open Input Actions
• In System, identify the device and expand to Control Inputs
• Drag the desired Input Action to the on_action or the off_action
• Set relevant parameters in the dialog box that appears

Control Inputs - Monitoring

Control Input

• Conventional inputs have two states:
  • Contact is Open, or
  • Contact is Closed

This makes the control input vulnerable - cable break is not detected.
On System Controller and Amplifiers it is possible to monitor the control inputs. Access panels do not support monitoring.
This is done by connecting two resistors as close as possible to the external switch/relay, one in series and one in parallell.

Control Input - Monitored

The resistor connected in series with the external switch/relay shall have a value of 1 kΩ, while the resistor connected in parallel shall be 2.2 kΩ.

Monitored Inputs have four states:

• Contact is Open, or
• Contact is Closed
• Short circuit (error)
• Open circuit (error)

Monitoring of inputs must be enabled in EMT:

EMT - enable monitoring

Parallel Wired Inputs

In an A-B system, it is required that signals from external systems such as fire detection are routed to both the A and B systems.

Connection with Dual-Pole Switch

If the external system has two physical outputs, a dual-pole switch connection must be made between Exigo and the external system as shown below:

A - B Dual-Pole Switch Wiring

Connection with Single-Pole Switch

If the external system has only one physical output, a single-pole switch connection must be made between Exigo and the external system as shown below:

A - B Singel-Pole Switch Wiring

As the Exigo system uses a small current to detect the status of the external switch/relay, two inputs should not be directly connected together without due precautions.
To prevent currents from flowing the wrong way, and to ensure proper functioning of the control input, blocking diodes must be inserted in the loop as depicted in the figure above.

Voltage Levels

Control input is designed around a voltage measurement. Normal voltage will be 11,7V when nothing is connected.

Non monitored

Voltage measured on pins under 6,2 Volt is considered to be closed. Above 6,2 Volt and is considered to be open.

Monitored

11,1V <–> 8,2 V = Not connected
8,2V <-> 6,2 V = Open
6,2V <-> 2 V = Closed
2V <-> 0 = Shorted