CRM-V-GN

CRM-V-GN

Gooseneck Microphone for IP Flush Master

• Noise-cancelling gooseneck microphone for IP Flush Master station
• Ideal for Public Address and control room applications

Installation

1. Remove the cover plug from the opening for the microphone on the front panel.
2. Thread the microphone cable through the opening, the lock washer and nut.
3. Tighten the nut on the microphone’s threaded stud.
4. Insert the microphone’s IDC socket into the upper two pins of the 3-pin header (J7) located at the lower left side of the station. The signal wire (white) should be on the top pin while the ground wire (green) should be on the bottom pin.
5. Slide the S1 switch (bottom back of station) to EXT to activate the external microphone function.

CRM-V-GN Installation

Connection

The mic connector should be on the two upper pins of the IP Flush Station.

Signal wire (white) on the top pin.
Ground wire (green) on the bottom pin.
The switch on the IP Flush Station must be set to the "EXT"-position.

Gooseneck microphone connection

Gooseneck microphone connection, detailed

Additional documentation

For more documentation, please visit the Zenitel web page: https://www.zenitel.com/product/crm-v-gn