Difference between revisions of "IP Configuration"
Jump to navigation
Jump to search
| Line 15: | Line 15: | ||
* Open the front cover on the ESC1. | * Open the front cover on the ESC1. | ||
* Connect a PC to the service port (npe_eth0). This has '''169.254.1.5''' as default IP. | * Connect a PC to the service port (npe_eth0). This has '''169.254.1.5''' as default IP. | ||
| + | * Log on with a Web Browser (admin/alphaadmin). | ||
| + | * Go to '''System Configuration''' -> '''Interfaces''' and set the desired IP Address of the Primary Controller (npe_eth1). | ||
| + | |||
| + | |||
Revision as of 16:50, 22 November 2016
This article describes how to configure the IP settings in Exigo.
Initially all devices must be configured with:
- Own IP address
- IP Address of Domain Controller
- ID number (Directory Number)
- Default Gateway
Creating a table with relevant information is considered good practice.
Primary System Controller
To set the IP address for the Primary System Controller do the following:
- Open the front cover on the ESC1.
- Connect a PC to the service port (npe_eth0). This has 169.254.1.5 as default IP.
- Log on with a Web Browser (admin/alphaadmin).
- Go to System Configuration -> Interfaces and set the desired IP Address of the Primary Controller (npe_eth1).
