Difference between revisions of "Firewall Settings"
| Line 52: | Line 52: | ||
[[File:Firewall 3.JPG|thumb|left|500px|Default Firewall Setting]] | [[File:Firewall 3.JPG|thumb|left|500px|Default Firewall Setting]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| + | Select the desired firewall/port. <br> | ||
This settings will then be default for all devices. | This settings will then be default for all devices. | ||
| Line 59: | Line 60: | ||
[[File:Firewall 4.JPG|thumb|left|500px|Individual Firewall Setting]] | [[File:Firewall 4.JPG|thumb|left|500px|Individual Firewall Setting]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| − | To change firewall setting: remove the '''Use System Setting''' checking. | + | To change firewall setting:<br> |
| + | Select the desired firewall/port and remove the '''Use System Setting''' checking. | ||
[[Category:Troubleshooting]] | [[Category:Troubleshooting]] | ||
[[Category:Getting started]] | [[Category:Getting started]] | ||
Revision as of 13:19, 15 December 2016
This article describes the firewall/filter settings needed for the Exigo System.
There might be different needs for different system setups.
This settings are what is needed as a minimum to get the system working.
Firewall Settings
On the Primary System Controller (AMC-IP board) the minimum filters needs to be enabled for Eth1:
| Protcol | Port |
|---|---|
| ZAP (Zenitel Application Protocol) | TCP-50004 |
| NTP server | UDP-123 |
| VoIP Audio | UDP-61000:61150 |
| IP Stations | TCP-50001 |
| HTTP | TCP-80 |
For AlphaCom/SIP integration:
| Protcol | Port |
|---|---|
| SIP | UDP-5060 |
To adjust filters go to System Configuration -> Filters:
Setup wizard
During creation of a new database it is possible to open up for SNMP traffic in the system.
Enabling SNMP can be done on the last page of the wizard.
Default Firewall Setting
The default firewall settings for all endpoints can be changed in EMT.
In the device tree go to System -> Default Firewall Setting:
Select the desired firewall/port.
This settings will then be default for all devices.
Individual Settings
It is possible to set individual firewall setting for each device (not recommended).
In the device tree go to the desired device -> Network Interface -> Firewall:
To change firewall setting:
Select the desired firewall/port and remove the Use System Setting checking.
