Fault System
Jump to navigation
Jump to search
This article describes how the fault system in Exigo works.
All the devices in the system reports faults and changes in fault status to the Primary System Controller.
The Primary System Controller maintains a fault list.
Each fault can have multiple states:
- New - Fault is new and not acknowledged
- Acknowledged - Fault is acknowledged from GUI on ESC1
- Gone - Fault have been solved, but it has not been reset
Faults will be active until the device which reported it reports that it is gone.
Faults will be active in ESC1 GUI until it is acknowledged, gone and reset.
Monitoring
It is possible to customize the monitoring of the system.
This can be done when creating a new database using the wizard:
It is also possible to customize the monitoring later.
Go to device three -> System -> Default Configuration: