Difference between revisions of "ENA2100-AC One Channel Mode"
(→Status LED) |
(→Status LED) |
||
| Line 16: | Line 16: | ||
[[File:ENA2100 one channel mode 2.jpg|thumb|left|400px|One Channel Mode LED indication]] | [[File:ENA2100 one channel mode 2.jpg|thumb|left|400px|One Channel Mode LED indication]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| − | |||
It is recommended to check that the "One Channel LED" is turned '''ON''' before bridging the two channels. | It is recommended to check that the "One Channel LED" is turned '''ON''' before bridging the two channels. | ||
Revision as of 12:03, 10 January 2019
The ENA2100-AC Amplifier supports One Channel Mode.
When "One Channel mode" is activated, the two loudspeaker channels will play identical audio, and the audio will be in phase.
One can then choose to use two separate loudspeaker loops, each with maximum 100W, or one can bridge the two output channels, and use one loudspeaker loop with up to 200W load.
Configuration
One Channel Mode is configured in EMT.
Go to System -> ENA2100 -> Audio Line.
Status LED
There is a green LED inside the Amplifier, right behind the loudspeaker connector, which will turn ON when "One Channel mode" is active.
The LED can be seen through the rear grille.
It is recommended to check that the "One Channel LED" is turned ON before bridging the two channels.
Availability
This function is available from Exigo 1.4 and later.
