AC and DC power monitoring
This article explains how to enable monitoring for bot AC and DC power input.
The Exigo ESC1 and the ENA2200 can be connected to a primary AC power source and a secondary DC power source.
Switch-over between these power supplies is seamless and controlled by the units themselves.
The power input monitoring can be individually turned on or off.
Database Wizard
When creating a new database using the wizard both the AC and the DC power monitoring is by default turned off:
Selecting this will turn on AC or DC monitoring for all ESC1 and ENA devices in the system.
EMT Settings
All the settings in the wizard can be changed later on, including AC and DC monitoring.
In the device three go to System -> Default Configuration:
These settings will change AC and DC monitoring for all ESC1 and ENA devices in the system.
Individual Settings
It is also possible to not use system settings but use individual setting for each ESC1 or ENA device.
In the device three got to the desired device -> Power Sources:
If you then remove the tick off Use System Setting it is possible to individual turn on or off the AC or DC monitoring:
