Tick Tone Control

Tick tock control

Short description with links to other relevant concepts.

Settings

Parameters
Tick tone A	Which tick tone should be used in A system.
Tick tone B	Which tick should be used in B system
Activation	What should happen when this specific function is started (start/stop/toggle)
Destination	Pre selected zones. If no zones are selected dynamically selected zones will be used.
Repetitions	How many times the tick tone sequence should repeat or if it should loop.
Priority	Which priority the tick tone function should have. 100 is default.
Cycle time	How long each cycle should take
Offset B	How much start of playback of tick tone in B should be offset relative to A.
On interrupt	Cancel will cancel tick tone if any other activity is started in the zone
	Mute will que the tick tone until the zone is free of other activity with higher priority

Leds

Red led indicates that the function is active.

Use cases:

Case 1: Tick tone test with dynamic zones in an AB system

In this case one button is designated to the tick tone function, while multiple other buttons are used for zone select.

Parameters
Tick tone A	Tick Tone 1A
Tick tone B	Tick Tone 1B
Activation	Toggle
Destination	Empty
Repetitions	Loop
Priority	100 (default)
Cycle time	10 (default)
Offset B	1 (default)
On interrupt	Cancel

Description of what this solves.

Case 2: More use cases

In this case the button was used to indicate that there was activity in zone 4 or zone 5.

Parameters
Destination	What is this set too
Priority	Lorum ipsum

Description of what this solves.

Case xx: Additional use cases

In this case the button was used to indicate that there was activity in zone 4 or zone 5.

Parameters
Destination	What is this set too
Priority	Lorum ipsum

Description of what this solves

Availability

This function is available on Exigo 1.2 and newer.