Turbine Image Recovery

From exigoWiki
Revision as of 08:26, 18 August 2016 by Gsorensen (talk | contribs)
Jump to navigation Jump to search

This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.

It is important that this must be used as a last resort and the only way to reach the unit is using serial port.

This applies to the following devices:

  • ESC1 Controller - only the Secondary System Controller.
  • ENA Amplifiers
  • ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
  • EAPII-1/EAPII-6 Access Panels.
  • TKIS-2/TKIE-1 kits.

Prerequisite

The upgrade process is done by using the following tools:

  • Standard TFTP server.
  • Serial console to run the process.

In order to upload the firmware you need the following:

  • USB to Serial Cable. A tutorial on how to make the cable can be found here.

This cable must be used for the access panels and the kits.

  • For the ESC Controller and ENA Amplifiers you need to use a serial cable like this:
Serial cable for ESC and ENA units


Connection

A tutorial on how to connect PC to Turbine device can be found here.

Procedure

Prepare the TFTP server on the PC

The TFTP server must be prepared with a image package (exi-x.x.x.x).

On a standard TFTP server extract and store the archive to the TFTP root folder.

Step-By-Step

  1. Connect the modified USB cable to the turbine device.
  2. Connect a Ethernet cable for the new Image transfer.