Default Configuration

From exigoWiki
Revision as of 14:07, 8 November 2018 by Gsorensen (talk | contribs) (Rack Devices)
Jump to navigation Jump to search
Default Configuration

This article explains the different default configuration settings available in Exigo.

The Default Configuration has 3 sections:

  • Rack Devices
  • Access Panels and Kits
  • System Settings

The settings are located under System -> Default Configuration.

Rack Devices

Rack Devices


  • Eth Port Monitoring - enable/disable monitoring of the Ethernet ports.
  • AC Monitoring - enable/disable monitoring of the AC power.
  • DC Monitoring - enable/disable monitoring of the DC power.
  • Amplifier Line Voltage - 100 Volt or 70 Volt.
  • Report Line Faults as Warning - Line Faults will be reported as Warnings instead of faults.
  • Missing Device Reporting - In Primary, In Both or None.

Access Panels and Kits

Access Panels an Kits


  • Eth Port Monitoring - enable/disable monitoring of the Ethernet ports.
  • Missing Device Reporting - In Primary, In Both or None.

System Settings

System Settings


  • Override Volume Control on Priority - select the priority where the Override Volume Control will be enabled.
  • Audio Device Mode - select Voice or HD Audio. More information here.
  • Missing Unregistered Device Report Time - Defines the time (in seconds) after startup when the Controller starts reporting 'Missing Device'.
Enable - Unchecking will turn off Missing Unregistered Device Reporting.
  • Delay 'Missing Device' Report - if set, suppress 'Missing Device' report for devices if the device is missing for less time than the limit set in 'Missing Debounce Time'.
  • Missing Debounce Time - Delay for debouncing 'Missing Device' reports.