Difference between revisions of "Turbine Image Recovery"
(→Connection) |
|||
Line 27: | Line 27: | ||
== Connection == | == Connection == | ||
− | A tutorial on how to connect PC to | + | A tutorial on how to connect PC to the access panels and kits can be found [http://exigowiki.zenitel.com/index.php?title=Turbine_to_PC_physical_connection '''here''']. |
+ | |||
+ | To connect to '''ESC''' Controller and '''ENA''' Amplifiers you must use the cable that is described above. | ||
== Procedure == | == Procedure == |
Revision as of 08:35, 18 August 2016
This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.
It is important that this must be used as a last resort and the only way to reach the unit is using serial port.
This applies to the following devices:
- ESC1 Controller - only the Secondary System Controller.
- ENA Amplifiers
- ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
- EAPII-1/EAPII-6 Access Panels.
- TKIS-2/TKIE-1 kits.
Contents
Prerequisite
The upgrade process is done by using the following tools:
- Standard TFTP server.
- Serial console to run the process.
In order to upload the firmware you need the following:
- USB to Serial Cable. A tutorial on how to make the cable can be found here.
This cable must be used for the access panels and the kits.
- For the ESC Controller and ENA Amplifiers you need to use a serial cable like this:
- TFTP server with the image package. TFTP server
- SSH client. PuTTY:
Connection
A tutorial on how to connect PC to the access panels and kits can be found here.
To connect to ESC Controller and ENA Amplifiers you must use the cable that is described above.
Procedure
Prepare the TFTP server on the PC
The TFTP server must be prepared with a image package (exi-x.x.x.x).
On a standard TFTP server extract and store the archive to the TFTP root folder.
Step-By-Step
- Connect the modified USB cable to the turbine device.
- Connect a Ethernet cable for the new Image transfer.