Difference between revisions of "Turbine Image Recovery"
Jump to navigation
Jump to search
Line 23: | Line 23: | ||
== Procedure == | == Procedure == | ||
− | === Prepare the TFTP server on the PC == | + | === Prepare the TFTP server on the PC === |
The TFTP server must be prepared with a image package (exi-x.x.x.x). | The TFTP server must be prepared with a image package (exi-x.x.x.x). | ||
+ | On a standard TFTP server extract and store the archive to the TFTP root folder. | ||
+ | === Step-By-Step === | ||
+ | #Connect the modified USB cable to the turbine device. | ||
+ | #Connect a Ethernet cable for the new Image transfer. | ||
− | |||
− | |||
Revision as of 13:58, 17 August 2016
This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.
This applies to the following devices:
- ESC1 Controller - only the Secondary System Controller.
- ENA Amplifiers
- ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
- EAPII-1/EAPII-6 Access Panels.
- TKIS-2/TKIE-1 kits.
Contents
Prerequisite
The upgrade process is done by using the following tools:
- Standard TFTP server.
- Serial console to run the process.
In order to upload the firmware you need the following:
- USB Cable. A toturial on how to make the cable can be found here.
- TFTP server with the image package. TFTP server
- SSH client. PuTTY:
Connection
A tutorial on how to connect PC to Turbine device can be found here.
Procedure
Prepare the TFTP server on the PC
The TFTP server must be prepared with a image package (exi-x.x.x.x).
On a standard TFTP server extract and store the archive to the TFTP root folder.
Step-By-Step
- Connect the modified USB cable to the turbine device.
- Connect a Ethernet cable for the new Image transfer.