Difference between revisions of "ENA2100-AC One Channel Mode"

From exigoWiki
Jump to navigation Jump to search
(Status LED)
Line 13: Line 13:
 
There is a green LED inside the Amplifier, right behind the loudspeaker connector, which will turn ON when "One Channel mode" is active. <br>
 
There is a green LED inside the Amplifier, right behind the loudspeaker connector, which will turn ON when "One Channel mode" is active. <br>
 
The LED can be seen through the rear grille.
 
The LED can be seen through the rear grille.
 +
 +
[[File:ENA2100 one channel mode 2.jpg|left|600px|One Channel Mode LED indication]]
 +
<br style="clear:both;" />
 +
 +
It is recommended to check that the "One Channel LED" is turned '''ON''' before bridging the two channels.
  
 
== Availability ==
 
== Availability ==

Revision as of 11:01, 10 January 2019

The ENA2100-AC Amplifier supports One Channel Mode.

When "One Channel mode" is activated, the two loudspeaker channels will play identical audio, and the audio will be in phase.
One can then choose to use two separate loudspeaker loops, each with maximum 100W, or one can bridge the two output channels, and use one loudspeaker loop with up to 200W load.

Configuration

One Channel Mode is configured in EMT.
Go to System -> ENA2100 -> Audio Line.

ENA2100-AC One Channel Mode


Status LED

There is a green LED inside the Amplifier, right behind the loudspeaker connector, which will turn ON when "One Channel mode" is active.
The LED can be seen through the rear grille.

One Channel Mode LED indication


It is recommended to check that the "One Channel LED" is turned ON before bridging the two channels.

Availability

This function is available from Exigo 1.4 and later.