Difference between revisions of "Turbine Image Recovery"

From exigoWiki
Jump to navigation Jump to search
(Upgrade Procedures)
(Upgrade Procedures)
Line 12: Line 12:
 
== Upgrade Procedures ==
 
== Upgrade Procedures ==
  
* A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found [https://wiki.zenitel.com/wiki/Turbine_Stations_-_Image_recovery '''here'''].
+
A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found [https://wiki.zenitel.com/wiki/Turbine_Stations_-_Image_recovery '''here'''].
 
 
 
 
 
 
 
 
 
 
  
  
 
[[Category:Troubleshooting]]
 
[[Category:Troubleshooting]]

Revision as of 11:43, 12 December 2018

This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.

It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.

This applies to the following devices:

  • ESC1 Controller - only the Secondary System Controller.
  • ENA Amplifiers
  • ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
  • EAPII-1/EAPII-6 Access Panels.
  • TKIS-2/TKIE-1/TKIE-2 kits.

Upgrade Procedures

A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found here.