Difference between revisions of "Turbine Image Recovery"
Jump to navigation
Jump to search
(→Upgrade Procedures) |
|||
| Line 12: | Line 12: | ||
== Upgrade Procedures == | == Upgrade Procedures == | ||
| − | # A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found [https://wiki.zenitel.com/wiki/Turbine_Stations_-_Image_recovery here]. | + | # A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found [https://wiki.zenitel.com/wiki/Turbine_Stations_-_Image_recovery '''here''']. |
Revision as of 11:42, 12 December 2018
This article describes how to upload firmware to a Turbine device if the firmware is corrupted and the unit is bricked.
It is important that this must be used as a last resort and if the only way to reach the unit is using serial port.
This applies to the following devices:
- ESC1 Controller - only the Secondary System Controller.
- ENA Amplifiers
- ECPIR-P/ECPIR-3P/EAPIR-8 Access Panels.
- EAPII-1/EAPII-6 Access Panels.
- TKIS-2/TKIE-1/TKIE-2 kits.
Upgrade Procedures
- A complete guide on recovery with the use of VS-Turbine.ImageUpgrade application can be found here.
