Difference between revisions of "Firewall Settings"
Jump to navigation
Jump to search
(→Default Firewall Setting) |
|||
| Line 50: | Line 50: | ||
The default firewall settings for all endpoints can be changed in EMT.<br> | The default firewall settings for all endpoints can be changed in EMT.<br> | ||
In the device tree go to '''System''' -> '''Default Firewall Setting''': | In the device tree go to '''System''' -> '''Default Firewall Setting''': | ||
| + | [[File:Firewall 2.JPG|thumb|left|500px|Default Firewall Setting]] | ||
| + | <br style="clear:both;" /> | ||
| + | This settings will then be default for all devices. | ||
| + | |||
[[Category:Troubleshooting]] | [[Category:Troubleshooting]] | ||
[[Category:Getting started]] | [[Category:Getting started]] | ||
Revision as of 10:51, 15 December 2016
This article describes the firewall/filter settings needed for the Exigo System.
There might be different needs for different system setups.
This settings are what is needed as a minimum to get the system working.
Firewall Settings
On the Primary System Controller (AMC-IP board) the minimum filters needs to be enabled for Eth1:
| Protcol | Port |
|---|---|
| ZAP (Zenitel Application Protocol) | TCP-50004 |
| NTP server | UDP-123 |
| VoIP Audio | UDP-61000:61150 |
| IP Stations | TCP-50001 |
| HTTP | TCP-80 |
For AlphaCom/SIP integration:
| Protcol | Port |
|---|---|
| SIP | UDP-5060 |
To adjust filters go to System Configuration -> Filters:
Setup wizard
During creation of a new database it is possible to open up for SNMP traffic in the system.
Enabling SNMP can be done on the last page of the wizard.
Default Firewall Setting
The default firewall settings for all endpoints can be changed in EMT.
In the device tree go to System -> Default Firewall Setting:
This settings will then be default for all devices.
