Difference between revisions of "Firewall Settings"
Jump to navigation
Jump to search
(→Setup wizard) |
|||
| Line 45: | Line 45: | ||
[[File:Firewall 2.JPG|thumb|left|500px|Setup wizard - SNMP]] | [[File:Firewall 2.JPG|thumb|left|500px|Setup wizard - SNMP]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| + | Enabling SNMP can be done on the last page of the wizard. | ||
| + | == Default Firewall Setting == | ||
[[Category:Troubleshooting]] | [[Category:Troubleshooting]] | ||
[[Category:Getting started]] | [[Category:Getting started]] | ||
Revision as of 10:29, 15 December 2016
This article describes the firewall/filter settings needed for the Exigo System.
There might be different needs for different system setups.
This settings are what is needed as a minimum to get the system working.
Firewall Settings
On the Primary System Controller (AMC-IP board) the minimum filters needs to be enabled for Eth1:
| Protcol | Port |
|---|---|
| ZAP (Zenitel Application Protocol) | TCP-50004 |
| NTP server | UDP-123 |
| VoIP Audio | UDP-61000:61150 |
| IP Stations | TCP-50001 |
| HTTP | TCP-80 |
For AlphaCom/SIP integration:
| Protcol | Port |
|---|---|
| SIP | UDP-5060 |
To adjust filters go to System Configuration -> Filters:
Setup wizard
During creation of a new database it is possible to open up for SNMP traffic in the system.
Enabling SNMP can be done on the last page of the wizard.
