Difference between revisions of "IP Configuration"
Jump to navigation
Jump to search
Line 12: | Line 12: | ||
== Primary System Controller == | == Primary System Controller == | ||
− | To set the IP address for the Primary System Controller | + | To set the IP address for the Primary System Controller: |
* Open the front cover on the ESC1. | * Open the front cover on the ESC1. | ||
* Connect a PC to the service port (npe_eth0). This has '''169.254.1.5''' as default IP. | * Connect a PC to the service port (npe_eth0). This has '''169.254.1.5''' as default IP. | ||
* Log on with a Web Browser (admin/alphaadmin). | * Log on with a Web Browser (admin/alphaadmin). | ||
* Go to '''System Configuration''' -> '''Interfaces''' and set the desired IP Address of the Primary Controller (npe_eth1). | * Go to '''System Configuration''' -> '''Interfaces''' and set the desired IP Address of the Primary Controller (npe_eth1). | ||
+ | |||
+ | == Secondary System Controller == | ||
+ | To configure the IP setting for the Secondary System Controller: | ||
+ | * Connect a PC to either Eth1 or Eth2 on [[ESC-1 | ESC1]]. | ||
+ | Log on to SSC with a Web Browser | ||
+ | Set the IP Address of the SSC | ||
+ | Set IP address of the Domain Controller | ||
+ | Set the Directory Number | ||
+ | |||
Revision as of 16:53, 22 November 2016
This article describes how to configure the IP settings in Exigo.
Initially all devices must be configured with:
- Own IP address
- IP Address of Domain Controller
- ID number (Directory Number)
- Default Gateway
Creating a table with relevant information is considered good practice.
Primary System Controller
To set the IP address for the Primary System Controller:
- Open the front cover on the ESC1.
- Connect a PC to the service port (npe_eth0). This has 169.254.1.5 as default IP.
- Log on with a Web Browser (admin/alphaadmin).
- Go to System Configuration -> Interfaces and set the desired IP Address of the Primary Controller (npe_eth1).
Secondary System Controller
To configure the IP setting for the Secondary System Controller:
- Connect a PC to either Eth1 or Eth2 on ESC1.
Log on to SSC with a Web Browser Set the IP Address of the SSC Set IP address of the Domain Controller Set the Directory Number