Difference between revisions of "ENA2100-AC One Channel Mode"
Jump to navigation
Jump to search
(→Status LED) |
|||
| Line 11: | Line 11: | ||
== Status LED == | == Status LED == | ||
| − | + | There is a green LED inside the Amplifier, right behind the loudspeaker connector, which will turn ON when "One Channel mode" is active. <br> | |
| + | The LED can be seen through the rear grille. | ||
== Availability == | == Availability == | ||
Revision as of 10:45, 10 January 2019
The ENA2100-AC Amplifier supports One Channel Mode.
When "One Channel mode" is activated, the two loudspeaker channels will play identical audio, and the audio will be in phase.
One can then choose to use two separate loudspeaker loops, each with maximum 100W, or one can bridge the two output channels, and use one loudspeaker loop with up to 200W load.
Configuration
One Channel Mode is configured in EMT.
Go to System -> ENA2100 -> Audio Line.
Status LED
There is a green LED inside the Amplifier, right behind the loudspeaker connector, which will turn ON when "One Channel mode" is active.
The LED can be seen through the rear grille.
Availability
This function is available from Exigo 1.4 and later.
