Difference between revisions of "Default Configuration"

From exigoWiki
Jump to navigation Jump to search
(Rack Devices)
(System Settings)
 
(One intermediate revision by the same user not shown)
Line 15: Line 15:
 
* DC Monitoring - enable/disable monitoring of the DC power.
 
* DC Monitoring - enable/disable monitoring of the DC power.
 
* Amplifier Line Voltage - '''100 Volt''' or '''70 Volt'''.
 
* Amplifier Line Voltage - '''100 Volt''' or '''70 Volt'''.
* Report Line Faults as Warning - Line Faults will be reported as Warnings instead of faults.  
+
* Report Line Faults as Warning - Line Faults will be reported as Warnings instead of Faults.  
 
* Missing Device Reporting - '''In Primary''', '''In Both''' or '''None'''.
 
* Missing Device Reporting - '''In Primary''', '''In Both''' or '''None'''.
  
Line 29: Line 29:
 
* Override Volume Control on Priority - select the priority where the Override Volume Control will be enabled.
 
* Override Volume Control on Priority - select the priority where the Override Volume Control will be enabled.
 
* Audio Device Mode - select '''Voice''' or '''HD Audio'''. More information [[Audio Device Mode| here]].
 
* Audio Device Mode - select '''Voice''' or '''HD Audio'''. More information [[Audio Device Mode| here]].
 +
* No Beep on Call End - if set this turns off the cancel tone.
 
* Missing Unregistered Device Report Time - Defines the time (in seconds) after startup when the Controller starts reporting 'Missing Device'.
 
* Missing Unregistered Device Report Time - Defines the time (in seconds) after startup when the Controller starts reporting 'Missing Device'.
 
:: Enable - Unchecking will turn off Missing Unregistered Device Reporting.
 
:: Enable - Unchecking will turn off Missing Unregistered Device Reporting.

Latest revision as of 11:43, 16 August 2019

Default Configuration

This article explains the different default configuration settings available in Exigo.

The Default Configuration has 3 sections:

  • Rack Devices
  • Access Panels and Kits
  • System Settings

The settings are located under System -> Default Configuration.

Rack Devices

Rack Devices


  • Eth Port Monitoring - enable/disable monitoring of the Ethernet ports.
  • AC Monitoring - enable/disable monitoring of the AC power.
  • DC Monitoring - enable/disable monitoring of the DC power.
  • Amplifier Line Voltage - 100 Volt or 70 Volt.
  • Report Line Faults as Warning - Line Faults will be reported as Warnings instead of Faults.
  • Missing Device Reporting - In Primary, In Both or None.

Access Panels and Kits

Access Panels an Kits


  • Eth Port Monitoring - enable/disable monitoring of the Ethernet ports.
  • Missing Device Reporting - In Primary, In Both or None.

System Settings

System Settings


  • Override Volume Control on Priority - select the priority where the Override Volume Control will be enabled.
  • Audio Device Mode - select Voice or HD Audio. More information here.
  • No Beep on Call End - if set this turns off the cancel tone.
  • Missing Unregistered Device Report Time - Defines the time (in seconds) after startup when the Controller starts reporting 'Missing Device'.
Enable - Unchecking will turn off Missing Unregistered Device Reporting.
  • Delay 'Missing Device' Report - if set, suppress 'Missing Device' report for devices if the device is missing for less time than the limit set in 'Missing Debounce Time'.
  • Missing Debounce Time - Delay for debouncing 'Missing Device' reports.