Difference between revisions of "Basic Troubleshooting"
(→Firmware) |
|||
Line 25: | Line 25: | ||
A guide on firewall setting can be found [[Firewall Settings | here]]. | A guide on firewall setting can be found [[Firewall Settings | here]]. | ||
+ | == Restart Devices == | ||
+ | Restarting devices might help resolving problems with the system.<br> | ||
+ | === Chilly Restart === | ||
+ | From the web interface on the AMC-IP board it is possible to do a chilly restart.<br> | ||
+ | Go to '''System Maintenance''' -> '''System Recovery''': | ||
− | + | [[File:Basic troubleshooting 1.JPG|thumb|left|500px|AMC-IP web interface - Chilly Restart]] | |
+ | <br style="clear:both;" /> | ||
+ | In many cases this will be sufficient.<br> | ||
+ | If this do not work it might help to do a full restart of the devices (or turn the device off/on).<br> | ||
[[Category:Troubleshooting]] | [[Category:Troubleshooting]] |
Revision as of 14:57, 21 November 2016
This article describes basic troubleshooting for the Exigo system.
If you encounter problems making the Exigo system work the following steps might be useful for troubleshooting.
Contents
Firmware
Make sure that you are using the latest firmware on every part of your system.
The Exigo software releases comes in packages including software for:
- EMT
- Primary System Controller
- Access Panels, Network Amplifiers (ENA) and Secondary System Controller
- CRM Access Panel
- Flowire
Make sure you are using the latest firmware from the same package.
Using firmware/software from different packages may cause problems.
Web Server Access
Each device is equipped with a web interface. Make sure that it is possible to access each device via the interface.
This will make sure that all devices is online.
IP Address and Directory Number
Make sure that all the devices has the correct IP address and the correct directory number.
It is also important to set the default Gateway for each device.
Firewall (Filter) Settings
Make sure that you open up for all needed protocols in the firewall on the AMC-IP card.
A guide on firewall setting can be found here.
Restart Devices
Restarting devices might help resolving problems with the system.
Chilly Restart
From the web interface on the AMC-IP board it is possible to do a chilly restart.
Go to System Maintenance -> System Recovery:
In many cases this will be sufficient.
If this do not work it might help to do a full restart of the devices (or turn the device off/on).