Difference between revisions of "Setting up ELTSI-1/Line End Transponder"
(→EMT Configuration) |
(→EMT Configuration) |
||
| Line 13: | Line 13: | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
'''LET Monitoring:''' To Enable LET Monitoring this must be selected. | '''LET Monitoring:''' To Enable LET Monitoring this must be selected. | ||
| + | |||
| + | Proceed to '''Line End Transponders:''' | ||
| + | [[File:Eltsi 1 setting 2.JPG|thumb|left|500px|EMT - Line End Transponders]] | ||
| + | <br style="clear:both;" /> | ||
| + | |||
| + | |||
| + | |||
[[Category:Getting started]] | [[Category:Getting started]] | ||
Revision as of 14:42, 15 September 2016
This article will explain how to setup and configure the ELTSI-1/Line End Transponder in a system.
The line end transponder ensures reliable monitoring of the loudspeaker lines. Where impedance measurements may result in an erroneous report of a broken line, the line end transponder will always report the correct health of the loudspeaker loop.
Up to 10 line end transponders may be connected to the same amplifier output, making it possible to branch out the loudspeaker loops.
Setting the address
Each amplifier can have a total of 10 LETs (ELTSI-1) divided among the channels and each ELTSI-1 must have a unique address.
More information on how to set the address can be found here.
EMT Configuration
To enable LET monitoring on the speaker line go to ENA amplifier(s) -> Audio Lines -> Amplifier Output Channel x -> LET and Line monitoring:
LET Monitoring: To Enable LET Monitoring this must be selected.
Proceed to Line End Transponders:
