Configure ENSER-8

ENSER-8

This article explains the basics on how to configure the ENSER-8 (Cisco IE-3000-8TC).

Connect to the switch

To configure the switch use the cable that came with the switch and connect to the console port.

IE-3000-8TC - Connection port

Use a terminal that supports serial, for example PuTTY

• Baud rate default is 9600
• Data bits default is 8
• Stop bits default is 1
• Parity settings default is none

Initial Configuration Information

To set up the switch, you need to complete the setup program, which runs automatically after the switch is powered on.

Setup Program

Step 1

Enter yes at these two prompts:
Would you like to enter the initial configuration dialog? [yes/no]: yes
Would you like to enter basic management setup? [yes/no]: yes

Step 2

Enter a hostname for the switch, and press Return:
Enter host name [Switch]: host_name

Step 3

Enter an enable secret password, and press Return:
Enter enable secret: secret_password

Step 4

Enter an enable password, and press Return:
Enter enable password: enable_password

Step 5

Step 5 Enter a virtual terminal (Telnet) password, and press Return:
Enter virtual terminal password: terminal-password

Step 6

(Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts.
To configure SNMP later, enter no: Configure SNMP Network Management? [no]: no

Step 7

Enter the interface name (physical interface or VLAN name) of the interface that connects to the management network, and press Return. For this release, always use vlan1 as that interface.
Enter interface name used to connect to the management network from the above interface summary: vlan1

Understanding Command Modes

The Cisco user interface is divided into many different modes.
The commands available depend on which mode you are currently in.
Entering a question mark (?) will give you a list of commands available for each mode.
The four most used modes are:

• User EXEC
• Privileged EXEC
• Global configuration
• Interface configuration

Additional documentation

For more documentation, please visit the Zenitel web page: https://www.zenitel.com/product/enser-8

Cisco Industrial Ethernet 3000 Switches

Cisco IE-3000-8TC Software Configuration Guide