Release Note Exigo 1.3

Exigo 1.3.2.10

Release status: Limited Availability, available on request.
Release date: 28.04.2017
Software collection file: EXIGO-1.3.2.10.zip

Software included in EXIGO-1.2.3.13.zip

For upgrade procedures, see PDF document included in each product folder inside the EXIGO-1.3.2.10.zip file; except VS-DEVICE-MIB, as this may vary between monitoring tools.

Product	Version	Product description
EXI-Firmware	4.3.2.10	Firmware for the following devices: ESC1(Secondary System Controller), ENA2200, ENA2400, ECPIR-3P, ECPIR-P, EAPIR-8, EAPFX-1, EAPFX-6, EAPII-1, EAPII-6, TKIS-2, TKIE-2
AlphaSys Firmware	12.3.2.9	Firmware for the ESC1 (Primary System Controller/AMC-IP board)
Exigo Management Tools	1.3.2.9001	Configuration tool, installed on a Windows PC
INCA Firmware	2.20.3.8	Software for the CRM-V based panel
VS-DEVICE-MIB	201610190000Z	SNMP MIB for Exigo EXI-Devices, for upload in 3rd-party SNMP based monitoring tools

New features

Backup Amplifier (AL-100)

• One amplifier can be configured as a replacement for up to 6 other amplifiers.
• The “replacement candidates” can be prioritized from 1 to 6, where 1 is highest priority; so if more than one replacement candidate is lost, the one with the highest priority will be replaced.
• For details, see our wiki article

Alphacom and SIP integration (AL-38)

• Exigo supports full Alphacom integration and integration with other SIP trunks.
• Alphacom/SIP Integration is supporting single and AB systems
• An Exigo system can be integrated with multiple Alphacom/SIP systems.
• Alphacom/SIP connection link can be monitored by Exigo
• Alphacom/SIP stations can start and control any pre-configured audio activity in Exigo
• Exigo can send audio to Alphacom stations or groups
• Exigo can send audio via the SIP trunk to SIP stations
• Outgoing calls will have a priority translation from Exigo to standard SIP priorities.
• Control outputs can be triggered by incoming calls from the Alphacom/SIP system.
• For details about Alphacom integration, see our wiki article.
• For details about the SIP integration, see our wiki article.

IP speaker support (AL-52, AL-53)

• Exigo supports 200 IP speakers
• IP speakers are now a separate device in EMT

New Functionality

Turbine Extended kit support (AL-83)

• The Turbine Extended kit (TKIE-1/2) is now fully supported and can be configured in EMT.

Flowire Monitoring (AL-1306)

• For details, see our wiki article.

Auto mute function (AL-1372, AL-1823)

IP speakers and all other audio channels can be configured to be digitally muted based on activity in the system

ENA Line monitoring: Optional detailed reporting (AL-2592)

By default, the system reports both “Open” and “Shorted” as “Line Fault”. It is now possible to choose detailed reporting for “Open” and “Shorted”.

ENA Line monitoring: Suspend monitoring during alarms (AL-1388)

Amplifiers with high load can generate false load faults during GA. Suspend monitoring will pause monitoring during the alarm to prevent such faults.