Analog radio integration

This article describes how to set up analog radio integration in Exigo.
Exigo can be integrated with analog radio solutions by using control outputs and control inputs.

Audio from Exigo to Radio using ESC1

Audio from Exigo can be sent out on a radio. The radio will then be a special zone which are only used for radio.

Wiring

Radio interface from ESC-1 to GM360

Diagram shows wiring from ESC-1 to a GM360 radio. The same principle can be used for other radios from different manufacturers.
Other Exigo devices such as kits can be used instead of ESC1 when required. This is especially useful when the radio is located far from the ESC-1.

Configuration

Radio integration is for Exigo the same as any other analog audio integration.

1. Assign the line output to a zone. No other audio channels need to be part of this zone

Settings for audio activity when used for analog integration

2. Program audio activity on the control output which is used.
2a. In Zone add the zone which contains the line output.
2b. Set priority range to 1-100. All audio sent to the radio zone will now trigger the control output which will key the radio.