Configure ENSER-8
Jump to navigation
Jump to search
This article explains the basics on how to configure the ENSER-8 (Cisco IE-3000-8TC).
Connect to the switch
To configure the switch use the cable that came with the switch and connect to the console port.
Use a terminal that supports serial, for example PuTTY
- Baud rate default is 9600
- Data bits default is 8
- Stop bits default is 1
- Parity settings default is none
Understanding Command Modes
The Cisco user interface is divided into many different modes.
The commands available depend on which mode you are currently in.
Entering a question mark (?) will give you a list of commands available for each mode.
Additional documentation
For more documentation, please visit the Zenitel web page: https://www.zenitel.com/product/enser-8
Cisco IE-3000-8TC [manual]