Difference between revisions of "Configure ENSER-8"
(→Initial Configuration Information) |
|||
Line 15: | Line 15: | ||
== Initial Configuration Information == | == Initial Configuration Information == | ||
To set up the switch, you need to complete the setup program, which runs automatically after the switch is powered on. | To set up the switch, you need to complete the setup program, which runs automatically after the switch is powered on. | ||
− | + | === Setup Program === | |
− | + | '''Step 1''' | |
+ | Enter Yes at these two prompts:<br> | ||
+ | <code>Would you like to enter the initial configuration dialog? [yes/no]: yes<code> | ||
== Understanding Command Modes == | == Understanding Command Modes == |
Revision as of 11:02, 23 December 2016
This article explains the basics on how to configure the ENSER-8 (Cisco IE-3000-8TC).
Contents
Connect to the switch
To configure the switch use the cable that came with the switch and connect to the console port.
Use a terminal that supports serial, for example PuTTY
- Baud rate default is 9600
- Data bits default is 8
- Stop bits default is 1
- Parity settings default is none
Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch is powered on.
Setup Program
Step 1
Enter Yes at these two prompts:
Would you like to enter the initial configuration dialog? [yes/no]: yes
Understanding Command Modes
The Cisco user interface is divided into many different modes.
The commands available depend on which mode you are currently in.
Entering a question mark (?) will give you a list of commands available for each mode.
The four most used modes are:
- User EXEC
- Privileged EXEC
- Global configuration
- Interface configuration
Additional documentation
For more documentation, please visit the Zenitel web page: https://www.zenitel.com/product/enser-8
Cisco Industrial Ethernet 3000 Switches
Cisco IE-3000-8TC Software Configuration Guide