Difference between revisions of "Configure ENSER-8"
Jump to navigation
Jump to search
Line 3: | Line 3: | ||
== Connecting to the switch == | == Connecting to the switch == | ||
+ | To configure the switch use the cable that came with the switch and connect to the '''console port'''. | ||
− | + | * Baud rate default is 9600 | |
− | + | * Data bits default is 8 | |
+ | * Stop bits default is 1 | ||
+ | * Parity settings default is none | ||
Revision as of 14:53, 21 December 2016
This article explains the basics on how to configure the ENSER-8 (Cisco IE-3000-8TC).
Connecting to the switch
To configure the switch use the cable that came with the switch and connect to the console port.
- Baud rate default is 9600
- Data bits default is 8
- Stop bits default is 1
- Parity settings default is none