Difference between revisions of "Setting up a small A-B system"
Jump to navigation
Jump to search
| Line 8: | Line 8: | ||
With the PPT button we will configure Live Speech on all zones. | With the PPT button we will configure Live Speech on all zones. | ||
| + | Before you start configure make sure that all devices have been updated to the latest software/firmware. | ||
| + | ==Step 1: IP addresse== | ||
| + | Each device will need to be configured with an IP address and subnet which is in range of the AMC-IP card. | ||
| + | Table below lists IP range for a small system with one amplifier and on access panel. All subnets are set to 255.255.255.0 | ||
Revision as of 11:27, 22 August 2016
This article will explain how to setup and configure a small Exigo A-B system.
System A will have one ESC1 Controller and two ENA2200 Amplifiers.
System B will have one ESC1 Controller and two ENA2200 Amplifiers.
In addition there will be one ECPR-3P connected to the system.
The system will be programmed with 4 Zones.
With the PPT button we will configure Live Speech on all zones.
Before you start configure make sure that all devices have been updated to the latest software/firmware.
Step 1: IP addresse
Each device will need to be configured with an IP address and subnet which is in range of the AMC-IP card.
Table below lists IP range for a small system with one amplifier and on access panel. All subnets are set to 255.255.255.0
