View source for EAPFX Restore Factory Defaults

A EX access panel may have to be reset to its original factory default settings if, for instance, the password to the station web interface is forgotten. The defaults can either be set to Activated DHCP or Static IP.
 
 NOTE! A EAPFX Factory Default will also reset the Flowire NMK password. See [[Flowire_clusters#Setting_the_NMK_in_an_installation_with_TFIX_stations|here for more]]

== Preparation ==
# Connect a loudspeaker (8 ohms or higher) to the speaker output

== Reset to Factory Default Settings with Activated DHCP ==
[[File:EAPFX factory default1.PNG|thumb|250px|Factory Default with IP address from DHCP server]]
To reset:
:1.  While '''pressing any button''', power up the station.
:2.  Hold the button until the station audio starts counting, and release the button on '''count 1'''.
:3.  Press and hold the button on '''count 5''' and release on '''count 0'''.
::- if there is no 0 count, the procedure has failed and you have to start again
:4.  Press the '''call button''' to make the station say its IP address.

'''Factory default values'''
:Station IP address: (determined by DHCP server) 
:Username: '''admin'''
:Password: '''alphaadmin'''

<br style="clear:both;" />

== Reset to Factory Default Settings with Static IP ==
[[File:EAPFX factory default2.PNG|thumb|250px|Factory Default with Static IP Address]]
To reset:
:1.  While '''pressing any button''', power up the station.
:2.  Hold the button until the station audio starts counting, and release the button on '''count 1'''.
:3.  Press and hold the button on '''count 3''' and release on '''count 0'''.
::- if there is no 0 count, the procedure has failed and you have to start again
:4.  Press the '''call button''' to make the station say its IP address.

'''Factory default values'''
:Station IP address: '''169.254.1.100'''
:Username: '''admin'''
:Password: '''alphaadmin'''

<br style="clear:both;" />

[[Category:Troubleshooting]]